Showing all 8 results
Memory Recorder Options
-
CAN ADAPTER 8910
- Capture CAN-Bus information and convert them into analog/logic signals to input into your recorder or data logger.
- 2 ch CAN inputs.
- Analog 12 ch + 24-bit logic outputs.
-
DIFFERENTIAL PROBE 9322
- Measure high voltage with Hioki Memory HiCorders.
- Analyze potential differences included in common mode voltages, such as IGBT.
- Inspect commercial power line waveforms, such as on 400V power lines.
- For up to 2 kV DC or 1 kV AC.
- Frequency bandwidth up to 10MHz.
-
DIFFERENTIAL PROBE P9000
- Isolated testing of high voltage signals.
- Observe both instantaneous or RMS waveforms.
- Waveform only for exclusive use with Memory HiCorders (P9000-01) or waveform/RMS value switchable (P9000-02).
- For use with input of up to 1 kV AC/DC.
- Requires separate power supply.
-
LOGIC PROBE 9320-01
- Detect the presence of voltage or relay contact signals with Memory HiCorders.
- 4 channels for contact voltage signals.
- 500ns response.
- Miniature terminal type.
-
LOGIC PROBE 9327
- Detect the presence of voltage or relay contact signals with Memory HiCorders at high speeds.
- 4 channels for contact voltage signals.
- High-speed 100ns response.
-
LOGIC PROBE MR9321-01
- Logic probe for Memory HiCorders.
- Detect power line voltage interruptions.
- High speed response.
- 4 isolated channels.
- ON/OFF detection of AC/DC voltage.
- Large terminal type.
-
NON-CONTACT AC VOLTAGE PROBE SP3000
- Capture voltage signals from outside the wire cover.
- Supports φ1mm to 2.5mm covered wires.
- 10Hz to 100kHz frequency bandwidth.
- 5Vrms 14Vp-p rated measurement voltage.
-
NON-CONTACT CAN SENSOR SP7001, SP7002
- Innovative non-contact CAN/CAN FD sensor that improves testing productivity.
- Capture signals without affecting CAN bus or ECUs.
- No need to alter vehicle cables.
- High-sensitivity mode for hard to detect signals.