Showing 17–24 of 50 results
Cable Route Tracking & Identification
-
Seba KMT ESG NT Pinpointing Earth Fault Locator in sheath of underground cables
- high accuracy pinpointing of a sheath fault.
- Automatic adaptation to voltage level.
- Automatic filtration of interfering signals.
- Automatic zero calibration, no adjustments necessary.
- History mode.
- High-contrast color display.
-
Seba KMT EZ-Thump Cable Fault Location System on LV/MV Cables
- Easiest, fully automatic operation.
- All in one small and portable unit.
- ARM Prelocation.
- Pinpointing with 500 J.
- Available as 4 or 12 kV version.
- Bright, brilliant colour display.
- Battery operation.
-
Seba KMT Ferrolux FLE 10 Audio Frequency Receiver for Cable Location, Selection, Sheath Faults
- Precise direction guidance with right/left arrows.
- “SignalSelect” for clear route location.
- Depth and signal current intensity measurement at the push of a button.
- Route sensor weighs less than 1 kg for non-tiring use.
- “DirectSignal” for effective line location.
-
Seba KMT Geolux GL 660-1 Earth fault locator for fault location in isolated, earth free systems
- Earth fault locator for fault location in isolated, earth free systems.
- Mains filter for direct coupling to live cables up to 660 V.
- Pulsed output current for easier detection of the test signal.
- Filter for the suppression large interference signals.
- Location of earth faults up to 150 kOhm.
- No switch off during the fault location required.
- No influence to the signal lines connected to.
-
Seba KMT HVB-10 10kV Cable Fault Location, Steath Testing and Pinpointing Megger HVB10
- Output voltage 0 … 10 kV DC, bi-polar.
- Automatic test sequence.
- Bi-polar prelocation for the elimination of external influences.
- Detection and indication of wrong connections.
- Touchscreen and rotary encoder.
- Only one HV connection cable.
- Completely independent of the parameters of auxiliary lines.
-
Seba KMT KMK 8 Communications network cable tester
- Integrated Reflectometer (TDR).
- Active bridge for high precision R and C measurements and DC and AC fault location.
- Measurement by Graaf method in connection with an active slave at the far end.
- Passive Wheatstone bridge for R and C measurements and DC and AC fault location.
- Test Systems for Pre-measurement, Quick test and Quality testing.
- Measurement of interference voltages.
- Warning and information system.
- Remote control for the operation of the electronic far end loop control switch.
-
Seba KMT LPD Monitor On-line PD Partial Discharge Monitoring System for MV and HV
- Portable online PD measuring system for monitoring MV and HV systems.
- 16 channels.
- Allows effi cient forward planning of necessary maintenance work.
- Quick and easy to install.
- Integrated automatic knowledge-based evaluation of measured PD levels.
- Current status can be viewed at any time via remote access.
-
Seba KMT MFM 10 Cable Steath Fault Location System
- Testing, prelocation and pinpointing of sheath faults.
- Voltage up to ±10 kV DC.
- High current of up to 750 mA.
- Only one HV connection cable.
- Automatic measurement and protocolling.